![teraterm tutorial teraterm tutorial](http://intelpartner.weebly.com/uploads/1/2/4/9/124969301/191982495.png)
The Bus Pirate firmware defaults to a 115200bps/8/N/1 UART. This unpopulated header is a tap into the UART connection between the PIC microcontroller and the FTDI 232BL chip that provides the USB connection. Put a jumper between the PGC and PGD pins to trigger the on-board bootloader for firmware updates.Ĩ. The Bus Pirate firmware can also be updated over the USB connection using a bootloader, so the ICSP header is normally only used to program it the first time at the factory. These pins can be used to write new firmware to the microcontroller with a programmer like the PICKIT2 or ICD2. This 1x5 block of 0.1" pin header is the programming connection for the PIC 24FJ64GA002 microcontroller. In circuit serial programming (ICSP) header. Notes: * TX moved from CS to MOSI in firmware v0għ. Ground, connect to ground of test circuit Voltage input for on-board pull-up resistors (0-5volts). Master data in, slave out (SPI, JTAG) RX (UART)Īuxiliary IO, frequency probe, pulse-width modulator Master data out, slave in (SPI, JTAG), Serial data (1-Wire, I2C, KB), TX* (UART) See the pinout table below, or the Bus Pirate manual. This 2x5 block of 0.1" pin header connects the Bus Pirate to external circuits.
![teraterm tutorial teraterm tutorial](https://woodnew314.weebly.com/uploads/1/2/4/9/124903717/482174446.jpg)
This LED lights when the on-board power supplies have been activated from the user terminal (command capital 'W' ).Ħ. The pins should be in a safe, non-powered, high-impedance state when the mode LED is off.ĥ. The I/O pins might be active when the mode indicator is on.
![teraterm tutorial teraterm tutorial](https://microchipdeveloper.com/local--files/ble:bm70-app-example-transparent-uart-using-smartphone-demo/DataExchange2.png)
This LED lights when the Bus Pirate is configured for a protocol mode from the user terminal (menu 'm'). This LED lights when the Bus Pirate is powered by the USB supply.Ĥ. This LED flashes when there's traffic from the PIC to the PC.ģ. The Bus Pirate draws power from the USB port, and uses the data connection to communicate with the PC.Ģ.
Teraterm tutorial install#